|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
All COBB Tuning AccessPORT Flash for N54 335i Discussion Here
|
|
11-22-2012, 04:03 PM | #6579 | |
Captain
14
Rep 961
Posts |
Quote:
At that elevation your log looked good, no problem hitting req boost with plenty of WGDC to spare.
__________________
"I'm not surprised you get along well with all the other neighbours. If you put fifty children with Down's syndrome in a room there is going to be a lot of hugging." David Thorne
|
|
Appreciate
0
|
11-22-2012, 04:27 PM | #6580 | |
Professional Hitman
162
Rep 996
Posts |
Quote:
I'll get a few more logs over the next few days. Thanks
__________________
|
|
Appreciate
0
|
11-22-2012, 07:36 PM | #6581 | |
Captain
14
Rep 961
Posts |
Quote:
__________________
"I'm not surprised you get along well with all the other neighbours. If you put fifty children with Down's syndrome in a room there is going to be a lot of hugging." David Thorne
|
|
Appreciate
0
|
11-22-2012, 07:49 PM | #6582 | |
Banned
79
Rep 2,396
Posts
Drives: '08 E90 335i
Join Date: Jan 2012
Location: Northern NJ
|
Quote:
I'd also recommend you switch which cylinder you're logging the timing off of from Cylinder 1 to Cylinder 3-5. Cylinder 1 is on the end of the block & tends to be a less accurate representation then cylinders closer to the TB. |
|
Appreciate
0
|
11-24-2012, 07:07 AM | #6583 |
3r1k
30
Rep 360
Posts |
Just installed VRSF Down Pipe and put Stage 2 Tune Aggressive.
It feels slower for some reasons. Attached Datalog Stage 1 and Stage 2. Just confused :S I used Virtual Dyno to measure HP and it is less than before (I know this is not the holy grail but it is a good tool for comparison)
__________________
12.836 @ 109.75mph (Cobb - Accessport & VRSF DP)
|
Appreciate
0
|
11-24-2012, 11:38 AM | #6584 | |
Captain
14
Rep 961
Posts |
Quote:
As far as comparing the two: Stage 2 runs more boost in the mids than stage 1. The stage 2 datalogs have higher CATs, high enough to trigger the CAT correction table so your timing isn't as good as it could be. That means that the timing on stage 1 and stage 2 looks really similar. On a cold night the timing on stage 2 will look better. There's not really a BIG difference beyween stage 1 and 2 to begin with(with the exception that stage 2 should put down more torque in the low-mid range RPMS) and with those CATs on stage 2 it's even less of a difference. The car should still be a little quicker on stage 2.
__________________
"I'm not surprised you get along well with all the other neighbours. If you put fifty children with Down's syndrome in a room there is going to be a lot of hugging." David Thorne
|
|
Appreciate
0
|
11-24-2012, 12:17 PM | #6585 | |
Professional Hitman
162
Rep 996
Posts |
Quote:
This happened to me when I first switched to the e30 tune. Felt like crap at first, then I drove it the next morning and BAM!!
__________________
Last edited by Evil///M; 11-25-2012 at 03:13 PM.. |
|
Appreciate
0
|
11-25-2012, 12:39 AM | #6586 | |
3r1k
30
Rep 360
Posts |
Quote:
First run, there is a timing pull on 1st Cylinder. Second run, timing pull on 2nd Cylinder. Not sure :S Overall I think you guys are correct. Top end is the same however there is more torque down low around 3000-4000ish rpm.
__________________
12.836 @ 109.75mph (Cobb - Accessport & VRSF DP)
|
|
Appreciate
0
|
11-25-2012, 01:52 AM | #6587 | |
Professional Hitman
162
Rep 996
Posts |
Quote:
__________________
|
|
Appreciate
0
|
11-25-2012, 05:27 AM | #6588 |
3r1k
30
Rep 360
Posts |
I always use 98 RON (93 PON equivalent).
PS: I just put in new oil filter, engine oil (Liqui Moly 5w-30) and transmission oil
__________________
12.836 @ 109.75mph (Cobb - Accessport & VRSF DP)
|
Appreciate
0
|
11-25-2012, 11:20 AM | #6589 |
KOrey
26
Rep 548
Posts
Drives: 335i Coupe
Join Date: May 2012
Location: Philadelphia
|
08 335i coupe, Cobb ap stage 1+ ST aggressive v401, Ets 5 fmic, Stett Cai, Bsh Occ, Helix Bov.
can anybody help me reading logs? i searched and downloaded virtual dyno program and dont know exactly what to look. can you guys check my log out if its okay or bad just for this time please? datalog17.zip |
Appreciate
0
|
11-25-2012, 11:49 AM | #6590 | |
Lieutenant Colonel
50
Rep 1,677
Posts
Drives: 14' GMC Terrain SLT-2
Join Date: May 2011
Location: Folsom, Ca
|
Quote:
http://www.e90post.com/forums/showthread.php?t=696472
__________________
SOLD:: PTF Pro eTune by Dzenno / COBB S1+ E50 Alpina B3 Flash / ETS FMIC / ER CP / CPE DCI Last edited by VNeBLOB42; 11-25-2012 at 11:57 AM.. |
|
Appreciate
0
|
11-25-2012, 11:56 AM | #6591 |
Lieutenant Colonel
50
Rep 1,677
Posts
Drives: 14' GMC Terrain SLT-2
Join Date: May 2011
Location: Folsom, Ca
|
You mean 93-94 AKI equivalent
__________________
SOLD:: PTF Pro eTune by Dzenno / COBB S1+ E50 Alpina B3 Flash / ETS FMIC / ER CP / CPE DCI |
Appreciate
0
|
11-25-2012, 12:17 PM | #6592 | |
KOrey
26
Rep 548
Posts
Drives: 335i Coupe
Join Date: May 2012
Location: Philadelphia
|
Quote:
|
|
Appreciate
0
|
11-25-2012, 12:18 PM | #6593 |
3r1k
30
Rep 360
Posts |
Yes That's Correct, 93 for people who lives in US.
__________________
12.836 @ 109.75mph (Cobb - Accessport & VRSF DP)
|
Appreciate
0
|
11-25-2012, 12:26 PM | #6594 | |
Lieutenant Colonel
50
Rep 1,677
Posts
Drives: 14' GMC Terrain SLT-2
Join Date: May 2011
Location: Folsom, Ca
|
Quote:
try to just do a 3rd Gear Log, WOT from 2500 RPM to redline or 6500 RPM. go through 4th for a bit. read that link I posted, it will help you help us. this will also clean up graphs and charts when using VD or Excel Grapher.
__________________
SOLD:: PTF Pro eTune by Dzenno / COBB S1+ E50 Alpina B3 Flash / ETS FMIC / ER CP / CPE DCI |
|
Appreciate
0
|
11-25-2012, 12:27 PM | #6595 |
Lieutenant Colonel
50
Rep 1,677
Posts
Drives: 14' GMC Terrain SLT-2
Join Date: May 2011
Location: Folsom, Ca
|
but somehow i feel your 98 Ron is still better than 93 AKI.
__________________
SOLD:: PTF Pro eTune by Dzenno / COBB S1+ E50 Alpina B3 Flash / ETS FMIC / ER CP / CPE DCI |
Appreciate
0
|
11-25-2012, 12:33 PM | #6596 | |
Lieutenant Colonel
50
Rep 1,677
Posts
Drives: 14' GMC Terrain SLT-2
Join Date: May 2011
Location: Folsom, Ca
|
Quote:
gotta have a few WOT pulls before the car is fully adapted to the new tune.
__________________
SOLD:: PTF Pro eTune by Dzenno / COBB S1+ E50 Alpina B3 Flash / ETS FMIC / ER CP / CPE DCI |
|
Appreciate
0
|
11-25-2012, 12:47 PM | #6597 | |
KOrey
26
Rep 548
Posts
Drives: 335i Coupe
Join Date: May 2012
Location: Philadelphia
|
Quote:
|
|
Appreciate
0
|
11-25-2012, 03:47 PM | #6598 |
Lieutenant Colonel
50
Rep 1,677
Posts
Drives: 14' GMC Terrain SLT-2
Join Date: May 2011
Location: Folsom, Ca
|
__________________
SOLD:: PTF Pro eTune by Dzenno / COBB S1+ E50 Alpina B3 Flash / ETS FMIC / ER CP / CPE DCI |
Appreciate
0
|
11-25-2012, 03:50 PM | #6599 |
Captain
38
Rep 864
Posts
Drives: '08 E92 335i
Join Date: Apr 2012
Location: Dallas
|
So I tried to datalog today and when I push ok to begin datalog, the screen goes blank briefly then jumps to the "WGDC" live monitor, and says "not logging" under it.
Am I doing anything wrong? |
Appreciate
0
|
11-25-2012, 04:45 PM | #6600 | |
Lieutenant Colonel
50
Rep 1,677
Posts
Drives: 14' GMC Terrain SLT-2
Join Date: May 2011
Location: Folsom, Ca
|
Quote:
choose Live Data Log or Data Log, to data log choose Data Log there will be a warning note: push ok then choose your on screen option (if you don't choose and or move up or down within a few sec. it will default to WGDC) you AP will display as a gauge and say "not logging" then click the center button OK to log the AP should remain the same on screen gauge, but say "data Logging" If that doesn't work, then "reset data log lists" and try again. I know on mine if the data log lists are max out, the Boost gauge doesn't work when logging. EDIT: read the posts on your issues with Procede, how do you like the COBB so far?
__________________
SOLD:: PTF Pro eTune by Dzenno / COBB S1+ E50 Alpina B3 Flash / ETS FMIC / ER CP / CPE DCI Last edited by VNeBLOB42; 11-25-2012 at 04:55 PM.. |
|
Appreciate
0
|
Bookmarks |
|
|