[TrentOSU]

And I click the two down select buttons on my wheel and nothing happens...I'm not sure what to do. I followed the directions closer than anything.

[TrentOSU]

Any suggestions?

[infidel335]

It should zero out the gauges, after that click up in either button to see if the needles move. If not then re-check your connections. I forgot to fully insert the green power wire when I installed mine. It's easy to overlook things during the install.

[TrentOSU]

Originally Posted by infidel335

It should zero out the gauges, after that click up in either button to see if the needles move. If not then re-check your connections. I forgot to fully insert the green power wire when I installed mine. It's easy to overlook things during the install.

The yellow box that's supposed to appear didn't. I'm guessing its connections somewhere. Should I go back and reinstall everything?

[E90MIA]

Originally Posted by TrentOSU

The yellow box that's supposed to appear didn't. I'm guessing its connections somewhere. Should I go back and reinstall everything?

yes, this happened to me once. email terry if that doesnt work

[TrentOSU]

Fixed. I did the CAN wires the wrong way.

[Ml3456]

How do you zero the gauges on a 335i?

Thanks

[TrentOSU]

Originally Posted by Ml3456

How do you zero the gauges on a 335i?

Thanks

What do you mean? I didn't do anything to my gauges.

[Ml3456]

They needles don't land on the numbers on the gauges. 1 acyually lands at 1300 rpm mark, 2 at 2500, etc. U heard there is a way to re-zero the gauges. I'm going to try reloading the firmware this morning and see what happens.

[Ml3456]

Update:

I reinstalled the firmware with version 3. 135,335. I think I may have uploaded the G5 version. I still had to reset the cluster and set it for a 335 in menu 5, but it works fine. Took it for a test drive and I'm thinking this is too much fun and better get a charge pipe soon!!

[TrentOSU]

Now I know what you're talking about. I didn't have that issue. Mine came with the latest firmware.

It's a lot of fun...have you auto tuned it and done three hard redline pulls?

[Ml3456]

Not yet.
Update 2!

Changed it to 7) 135/335 ISO

Als0, had to reset the defaults so the wastegate, etc parameters were correct. Runs great. No redline pulls yet.

[TrentOSU]

Originally Posted by Ml3456

Not yet.
Update 2!

Changed it to 7) 135/335 ISO

Als0, had to reset the defaults so the wastegate, etc parameters were correct. Runs great. No redline pulls yet.

If you haven't done the pulls yet then Map 5 is pointless.

[Ml3456]

Probably need to put a charge pipe on before I go red line!!

[TrentOSU]

Originally Posted by Ml3456

Probably need to put a charge pipe on before I go red line!!

You're not pushing incredible amounts of boost...therefore your charge pipe is fine. My car and charge pipe have been just fine and I have had some "fun" with no issues. You're over thinking things...it's not like you're FBO.