|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Tips on drilling kerscher style carbon fiber lip?
|
|
05-02-2013, 07:32 PM | #1 |
Bit by Modbug
258
Rep 1,109
Posts |
Tips on drilling kerscher style carbon fiber lip?
Just bought the front bumper splitter/lip and it's not drilled, any tips on drilling it? Do i have to remove the front bumper to do this? Can't think of another way of marking spots to drill...
Thanks. |
05-02-2013, 10:18 PM | #3 |
Bit by Modbug
258
Rep 1,109
Posts |
|
Appreciate
0
|
05-02-2013, 10:46 PM | #5 |
Bit by Modbug
258
Rep 1,109
Posts |
|
Appreciate
0
|
05-02-2013, 11:31 PM | #6 |
Major General
1103
Rep 7,063
Posts |
Cut small pieces of 3m double sided tape on each of the screws at the bottom of the bumper and then with the help of someone position the lip and move it up directly where you'd like to position it. If done right the 3m will stick to the lip and off the bumper then you can start drilling with help of its positions.
__________________
E90 Build Thread (SOLD) http://www.e90post.com/forums/showthread.php?t=809436
F15 Build Thread (SOLD) http://f15.bimmerpost.com/forums/sho....php?t=1064084 |
Appreciate
0
|
Bookmarks |
|
|