|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Scrap N54 Engine Wiring Harness (MAP sensor connector)
|
|
12-05-2014, 07:38 PM | #1 |
New Member
0
Rep 13
Posts |
Scrap N54 Engine Wiring Harness (MAP sensor connector)
It's probably a long shot, but does anyone have a scrap N54 Pre-LCI Engine wiring harness they don't need anymore or know of someone who might?
I was looking under my hood because I just threw a code for a Manifold Air Pressure (MAP) Sensor voltage being too high. When I looked for the sensor I saw the remnants of a rodent nest right on top of the motor....must have wanted to stay warm with the cold weather while I was at parked at Seatac and decided to nibble on part of the wire harness connecting to the MAP sensor. I would imagine splicing in a connector is a lot easier than replacing the wire harness. |
Bookmarks |
|
|