|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Passing Readiness with Procede and Catless DP's?
|
|
11-10-2012, 12:54 AM | #1 |
Brigadier General
125
Rep 3,004
Posts |
Passing Readiness with Procede and Catless DP's?
Hi Everyone, I was curious if you are running Catless DP's will the Procede be able to pass the readiness test? My 2007 is up for SMOG by Jan 14 2013 (thank god no more Sniffer), but curious if anyone knew if MAP 0 will allow to pass readiness. The OBD won't be able to read the car in any other map as the Procede will the OBD reader.
Perhaps all I need is the O2 modifier from BMS and Map 0??
__________________
2007 E92 6MT SGM: MusicarNW Level 2, Procede Rev 2.5, FFTEC/Vishnu LPFP with Flexfuel Sensor and Flash, M3 Offset V701's, WaveTrac LSD, Michelin PSS, Downpipes, M3 Control Arms, TCKline D/A Suspension, LCI Tail lights, Lux AE's, ER Charge Pipe, DCI's, Mtech Front and Rear, M3 Sideskirts, HPF Stage 1 Clutch
|
11-10-2012, 01:15 AM | #2 |
Brigadier General
125
Rep 3,004
Posts |
FYI: Ran out to my garage with Procede on Map0 and I plugged in INPA, and all the readiness Flags seem A.O.K.
I have Catless DP's and running FlexFuel kit. I will need to install my stock intake for Visual as my DCI's may cause a failure of Visual
__________________
2007 E92 6MT SGM: MusicarNW Level 2, Procede Rev 2.5, FFTEC/Vishnu LPFP with Flexfuel Sensor and Flash, M3 Offset V701's, WaveTrac LSD, Michelin PSS, Downpipes, M3 Control Arms, TCKline D/A Suspension, LCI Tail lights, Lux AE's, ER Charge Pipe, DCI's, Mtech Front and Rear, M3 Sideskirts, HPF Stage 1 Clutch
|
Appreciate
0
|
11-10-2012, 07:28 AM | #3 |
Brigadier General
133
Rep 4,764
Posts |
Canclear off
o2 modifier on (catless - you may need to set in the 50-60 range). map 0 |
Appreciate
0
|
Bookmarks |
|
|