|
|
|
|
PLEASE HELP SUPPORT E90POST BY DOING YOUR TIRERACK SHOPPING FROM THIS BANNER, THANKS! |
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
***** 74.1mm to 72.56mm Hub Centric???
|
|
Wheels and Tires forum Sponsored by The Tire Rack
Please help to directly support e90post by doing your tirerack shopping from the above link. For every sale made through the link, e90post gets sponsor support to keep the site alive. Disclaimer |
|
Thread Tools | Search this Thread |
01-27-2013, 10:27 AM | #1 |
Lieutenant
35
Rep 445
Posts |
***** 74.1mm to 72.56mm Hub Centric???
Hi,
I looking to purchase some wheels that have a 74.1 bore hub (E39) can they be converted to 72.56 (E92)??? Has anyone used Hub Centric Ring adapters. I posted a link of the Hub Centric Ring adapters below. Any help will be appreciated thanks guys. 19x9.5 fronts 19x10.5 rears http://www.sonictuning.com/misc/74-1...-set-of-4.html
__________________
|
01-27-2013, 07:53 PM | #3 | |
Lieutenant
35
Rep 445
Posts |
Quote:
Front 9.5 x 19 et22 Rear 10.5 x 19 et20 I might have to roll my rear fenders. I'm going to run 235 front and 265 rear on my e92 non-m.
__________________
|
|
Appreciate
0
|
01-28-2013, 05:39 PM | #4 |
Average Car Exceeding Expectations (ACEE)
358
Rep 4,806
Posts |
I think this is going to look pretty good. Your fronts should stick out about 9mm and rears about 11mm. How low are you? and which wheels?
__________________
too much to list...just know its wide and bagged |
Appreciate
0
|
Bookmarks |
|
|