|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Vorsteiner E90 Hood Install Help
|
|
12-29-2008, 10:30 PM | #1 |
Brigadier General
84
Rep 3,106
Posts |
Vorsteiner E90 Hood Install Help
For those of you that have installed this hood before I have a few questions. I have a single sided CF hood.
I had no issues transferring over all of the hardware and putting the hood on however I ran into an issue when trying to install a M3 Hood shock. There seems to be a mark where the shock would fit, but there isn't. Am I supposed to drill a hole for the stud from the OEM hood? If I did that wouldn't it just spin around with nothing to hold the stud? Also for the Hood Roundel did anyone just drill the holes for it to fit or did your hoods come pre-drilled? Or did you cut off the pegs and just glue it on or something? Thanks
__________________
Delivered 28 May
|
12-29-2008, 11:29 PM | #2 |
Lieutenant General
1519
Rep 17,382
Posts |
you don't use the shocks for the VRS hood. It's a bit too strong and will crack the hood. I have mine just unbolted.
As for the roundels, i'd be wary of drilling it as it could crack as well. I'd dremel down the the nipples on the roundel and betlink or double side tape it down. Mine are drilled but it came like that. |
Appreciate
0
|
12-30-2008, 01:05 AM | #4 |
Brigadier General
84
Rep 3,106
Posts |
Thanks for the help Andrew, I'm not sure why my hood did not come with the Roundel holes pre-drilled, but I will take your advice and will dremel the tabs off
__________________
Delivered 28 May
|
Appreciate
0
|
Bookmarks |
|
|