|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
FS: Jb3 1.4 PNP 18 OHM board
|
|
01-29-2010, 10:04 AM | #1 |
New Member
3
Rep 29
Posts |
FS: Jb3 1.4 PNP 18 OHM board
Selling my JB3. I installed the 18 OHM resisters that allow you run higher maps (above 9). I installed the 18's, to use MAP 8 (with stock filter) and not get any 1/2 engine codes, ran 12.5's in that set up. Works great with zero problems. On map 7 with some 101 in the tank and zero other mods (not even intake filter) the car dynoed 355 RWHP on an all wheel drive dyno. $400+ shipping. Last edited by Jimbob65; 02-15-2010 at 05:19 PM.. |
01-29-2010, 10:12 AM | #2 |
Major General
159
Rep 5,689
Posts |
You have some balls running that high of boost with out supporting mods.
__________________
Legal Disclaimer: Anything I or anyone else says about my vehicle on this website(1addicts.com or any affiliated or nonaffiliated sites), pertaining to modifications, is only to gain acceptance from my/our peers, and does not actually represent anything actually existing on my car, and thus, cannot be held against me in any issues, i.e. warranty claims, that may arise.
|
Appreciate
0
|
01-29-2010, 11:57 AM | #4 |
New Member
3
Rep 29
Posts |
The safety built in on the standard resisters gave me a 1/2 engine one time causing me to loose 1 tenth, and the bracket race. On the dyno thats about 16 psi on map 8.......with more mods map 10+ seem to work well for most! I like the stock look under the hood..
Last edited by Jimbob65; 02-01-2010 at 07:05 PM.. |
Appreciate
0
|
02-03-2010, 12:03 AM | #7 |
Lieutenant General
178
Rep 11,768
Posts |
plug and play. might want to include which gen board.
__________________
-Rev
SGM e92 335xi|Helix|AFE|AWE|PROCEDE|SYNAPSE|ER|OSS|BMW PERFORMANCE|P3|always growing.. |
Appreciate
0
|
Bookmarks |
|
|