|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Need help with rear brake lines.
|
|
02-09-2016, 10:54 AM | #1 |
Lieutenant Colonel
213
Rep 1,782
Posts |
Need help with rear brake lines.
I want to replace the rear blake lines to steel braided but the steel line itself is turning on the fitting because of rust. I tried this job a few months ago but only managed the fronts. I liberally sprayed it with WD-40 but no dice.
Figure 2 in this link explains it better http://www.pelicanparts.com/bmw/tech...rake-Lines.htm Any advice would be greatly appreciated, so I can finally finish this job.
__________________
Koni special active red, eibach pro-kit springs, Remus exhaust, stage 3 intake manifold,Stage 2 AA tune, BMW Short shift kit. Silicon intake pipe. M3 control arms front, M3 rear. ECS trailing arm with whiteline bushings. Purple powerflex subframe bushings. Yellow power flex upper shock mounts. Single mass flywheel OE weight.
|
02-09-2016, 11:50 AM | #2 |
Major General
4276
Rep 9,206
Posts |
wd-40 will not help you with that.
Try pb blaster or the best > aerokroil Soak a little piece of rag and tie it up on there and let it sit over night. Good luck! |
Appreciate
0
|
02-09-2016, 12:09 PM | #3 |
Lieutenant Colonel
213
Rep 1,782
Posts |
|
Appreciate
0
|
Bookmarks |
|
|