[Johnnybhoy7]

Hi guys I'm having a bit of trouble with my car. Basically I can't reset the front brake service light it's showing that the pads have 255% of wear left. It's a glitch within the system after it loses the data. After reading online for a bit I've been told I my dsc module needs programmed and then dsc/cbs data reset. From what people have said the best software to do this is BMW ISTA. Is there anyone on here who can do this remotely or someone in central Scotland who could do this for me?

[Mus22]

This is common matey any diagnostic can do it my Delphi does it also. If you look on ebay ista/d is about £40 ish its worth having.

http://www.ebay.co.uk/itm/LATEST-201...wAAOSwbiFZOmbX

[Johnnybhoy7]

Originally Posted by Mus22

This is common matey any diagnostic can do it my Delphi does it also. If you look on ebay ista/d is about £40 ish its worth having.

http://www.ebay.co.uk/itm/LATEST-201...wAAOSwbiFZOmbX

What Delphi do you have? I've got a few friends in the motor trade and even one with a snap on solus couldn't clear the light. The issue is that it needs to be edited and not reset. Or at least that's what I've read. I have seen Ista and to be honest I just don't feel comfortable enough to use it. I'd rather pay someone £40 who knows what they're doing than £40 for the software and I balls it up haha

[Mus22]

you are no where near me mate otherwise as a fellow BMW driver I would of done for you for nothing.


Delphi 2014.2 r2

[juld0zer]

Disconnect both pad sensors and wait a few mins, then reconnect them. Unlock the car, open door, close door and lock car and wait for it to go to sleep (eg. Gear selector light goes out on AT).

Then unlock and reset the CBS for the brakes.

Which axle brakes did you change? Are you 100% sure your sensors are new genuine ones or brand name aftermarket sensors?

[J0K3R5]

https://drive.google.com/open?id=0B7...HV0VmhFdUtsdlk