[King mode]

Originally Posted by shiv@vishnu

The last 100% e85 car we set-up ran 13.5@102-103mph stock and is currenlty running mid 11s @ 120mph with only downpipes and DCIs. Falls in line with the 175whp gain we are seeing when running straight e85.

In basic terms, a barely modified 335 running straight E85 makes more power than a FBO car running a 50/50 mix of race gas and E85. In fact, the car mentioned above broke our stock turbo hp record on our dyno. It was also the first car we tuned with straight E85. Which tells us there is plenty good stuff to come along in the near future.

Mixing E85 is cute. But running it straight is the bee's knees.

Shiv

Love it. It sucks running so slow at my altitude but at least us turbo cars lose less than n/a. I might switch to your e85 tune with just my drop in filter and see how much gain I see from my cobb. Based on the numbers I posted, what do you think I could run shiv?

[statelax3]

i looked on the website but did not see what flex fuel set up costs from shiv. anyone know?

[pinky_and_me]

Originally Posted by statelax3

i looked on the website but did not see what flex fuel set up costs from shiv. anyone know?

It's on the Procede v3 page after the pricing for the Procede.

[Evil///M]

So basically all that fuel sensor add on is for the computer to monitor the actual ethanol content/quality in the e85?

[jippii ensio]

Originally Posted by Evil///M

So basically all that fuel sensor add on is for the computer to monitor the actual ethanol content/quality in the e85?

...Procede reads the signal and adjusts the tune based on the measured ethanol content.

[Evil///M]

Originally Posted by jippii ensio

...Procede reads the signal and adjusts the tune based on the measured ethanol content.

That's what I said. Thanks.

[ABE92]

Originally Posted by shiv@vishnu

We eliminate the speed limiter with the ProcedeFlash. Which is why we can use the Procede's speed limiter i/o for the flexfuel sensor. Works just fine with the rev2.5. The rev3 is required, however, if you want to use flexfuel with pwm methanol control.

shiv

Sorry to bump an old thread but did you release the new flex fuel firmware that will allow pwm to work in conjunction with the flex fuel kit?

I have just uploaded the flex fuel firmware and pwm will not work on either map 2 or map 4.

[Kabnine]

Not to mention an update on the Flex Fuel Kits themselves?