[hikeven]

Recently I have been doing updates for my E90 2006 325i. I have done most of the modules including CAS. But I keep on getting this error for DME.

Error 106

Error on setting ECU-Address

Please check: Interface, PABD, P-SGBD

2000 Error Error in EDIABS or in ECU description file [SGBD] SYS-0005: object file not found 08MSV70

2000 Error Error in EDIABS or in ECU description file [SGBD] SET_ECU_ADDRESS

2000 Error Error in EDIABS or in ECU description file [SGBD] Run SET_ECU_ADDRESS job

I checked sgdat folder and 08MSV70 is there. Somehow DME is the only module I keep on getting this error. I tried to google it but with no luck.

Anyone got any ideas about how to get rid of this error? Thanks

[808AWD325xi]

Originally Posted by hikeven

Recently I have been doing updates for my E90 2006 325i. I have done most of the modules including CAS. But I keep on getting this error for DME.

Error 106

Error on setting ECU-Address

Please check: Interface, PABD, P-SGBD

2000 Error Error in EDIABS or in ECU description file [SGBD] SYS-0005: object file not found 08MSV70

2000 Error Error in EDIABS or in ECU description file [SGBD] SET_ECU_ADDRESS

2000 Error Error in EDIABS or in ECU description file [SGBD] Run SET_ECU_ADDRESS job

I checked sgdat folder and 08MSV70 is there. Somehow DME is the only module I keep on getting this error. I tried to google it but with no luck.

Anyone got any ideas about how to get rid of this error? Thanks

Did you check the EDIABAS\ECU folder for 08MSV70.PRG? If it's missing, you might not have imported your daten files into WinKFP properly. Suggest taking a look at the guide (steps 1-8):
WinKFP Import.pdf

[hikeven]

Originally Posted by 808AWD325xi

Did you check the EDIABAS\ECU folder for 08MSV70.PRG? If it's missing, you might not have imported your daten files into WinKFP properly. Suggest taking a look at the guide (steps 1-8):
WinKFP Import.pdf

Thanks a lot for that. Just figure it out. It seems P-SGBD hasn't been updated properly. I remembered I imported P-SGBD through Winkfp but somehow it did not work. I just copy all files to ECU folder and problem solved. Thanks

[808AWD325xi]

Originally Posted by hikeven

Thanks a lot for that. Just figure it out. It seems P-SGBD hasn't been updated properly. I remembered I imported P-SGBD through Winkfp but somehow it did not work. I just copy all files to ECU folder and problem solved. Thanks

Your welcome, glad to hear it worked out.

[Ilyas]

How much time approximately did it take to code each module? (I know there are lots of them, but anyways). Did you use fast baud rate?

[lalaura]

useful solution here: https://wobd2com.wordpress.com/2015/...106-error-806/

[Dericke92]

sorry to bother guys, but can anyone help me? I tried to flash the 330i tune on my 328. It went well but it was super slow so i decided to go back to normal/ stock. SO i used the stock files on bimmerlabs and now it wont start only crank