[italybooze]

I am installing my JB4 and everything seems to fine up until I am trying to reconnect the Large Slider. I can't get it to go all the way In I been trying for hours. It goes half way in and locks the connectors down. I tried leaving it like this and proceeded because it seems like the connectors were locked but then the car would crank and not start ?????

[Madill21]

Make sure it seats correctly! You need to have everything in the correct position with the slider half way in and then as you continue to push the slider in it should seat itself nicely. So the larger unit will lower itself into position as your pushing the slider in.

Everything just has to be in the right position. Good luck man! Let us know of you get it figured out.

[italybooze]

The connection for the power that plugs In to the male orange connection has broke off ... The male connection is inside the red power but the wire has disconnected from it broken I have a picture but it will not let me upload from iPhone

[italybooze]

I got the slider in I have a problem I posted above can you text me. ?

[Ntn125]

You can get a similar male terminal adapter from NAPA to finish the install. Just make sure it has the square collar to fit inside the harness. Email Terry and he will send another adapter. No worries, it happens and search for actual part number if you want to order from BMW for a few bucks. Good luck!

[italybooze]

So I just need to buy the male BMW connector right?

[solishe]

Order it from Terry. This happened to me and I went to RealOEM to get part number. I ordered from Terry and BMW and the BMW one was too small. Best bet to email Terry.