[eyim1988]

your jb is working fine. Im just saying your boost is low compared to mine haha.. I would help but i live in cali .

[e87fan89]

I'm gonna run map 2 than cuz map 5 I don't trust and with my AA charge pipe and downpipe I should be fine on map 2 with 93 octane

[e87fan89]

My car feels much faster in map 2 than on stock. I need a dyno mod apparently anyone sell one?

[WilliamS]

First Map5 allow for more boost over Map 2 but you have to run the car a few times to make Map 5 to learn whats best for your situation. Almost all cases you will have more boost than Map2 unless there is something wrong. Again you cant just switch to map 5 and expect it to boost higher, its a learning mode so you have to teach it. Few full throttle runs and it will adjust accordingly.

As for the Dyno, you sure you didnt have traction control on, as in you held the button for 5 seconds to shut the system down? As well you were up to full temp that lets the JB4 do its job, until 160 degrees on the oil you get no more power than stock. Perhaps even less.

We need to see the logs.

[e87fan89]

Oil temps were fine and traction was 100% off. On the street my car boosts to 15 on the dyno with map 2 my car won't boost over 7psi no matter what gear no matter what it just wont do it. This has to be an issue with the jb conflicting with my Ecu on the dyno. Otherwise I wouldn't feel the difference on the street

[Mike@N54Tuning.com]

You'll never know since you didn't log your dyno runs. Going forward a good first step is to do the N55 ISO firmware and a datalog to ensure it's running properly now.

Mike

[e87fan89]

I think my car isn't detecting enough load on the dyno to allow for more boost. Plus my car is a 2013 n55 135 so who knows what bmw changed. Maybe something with the way the car detects load? That's what a mechanic just told

[e87fan89]

What do you guys think about that?

[e87fan89]

Just wana keep this bumped as I I'd like people's input still

[e87fan89]

anyone have any thoughts on what that mechanic said about load?

[e87fan89]

Found out the 2013 1 series has a GPS detector thing In all four wheels if the car isn't moving the car can't dyno I should say if the GPS knows your car isn't moving also.....I dunno if this happens without idrive or nt as I have idrive but thought I'd let u guys know

[geared]

2012 here....i dynoed today - think i have the same issue.

[e87fan89]

It could be in late 2012 also I would think its most likely the same issue

[divisionbell77]

None of what you are saying makes any sense and all have completely disagreed with you and told you the same things.

1) you need logs

2) traction control or something else was most likely the cause.

[SflBimmer8484]

Originally Posted by geared

2012 here....i dynoed today - think i have the same issue.

Told you. At least you are not alone.

[divisionbell77]

Originally Posted by Andrew@ActiveAutowerke

Told you. At least you are not alone.

He was using map 5 and on a mustang dyno. He has posted over at terry's forum.

[SflBimmer8484]

Originally Posted by divisionbell77

He was using map 5 and on a mustang dyno. He has posted over at terry's forum.

He went to two different dynos with the same issue. I told him to run various maps to see if it would run the correct boost and it did not.

I also spoke with someone last night and they have the same problem.

I believe it has to do with the ecu noticing the front wheels are not spinning.

[Abear]

If the car is running fine off the dyno, just take it to the track to see where you stand. That 1320 feet will tell you everything your need to know.

[ragingpanda]

Originally Posted by Abear

If the car is running fine off the dyno, just take it to the track to see where you stand. That 1320 feet will tell you everything your need to know.

+1

Preach.