[F06msportmia]

What's up Forum!

I am looking for clarification or guidance on this.

My rear break sensor started to throw an error message that the breaks needed replacing. That lasted about 2 weeks, during that time I went out got pads, rotors, and a new sensor. But all of sudden the error message went away without me replacing breaks. Why is that???

I know I am do for a break change but why did the error message just go away?

Thanks for any insight!

[Glopez5]

false positives, i got the message 1k miles after replacing my pads. Then i had to reset service again. When you go to change your pads just take a look at the sensor and see if the tip is damaged. I would replace it anyway though.

Also, i highly recommend going w/ akebono ceramic pads and say bye to brake dust.

[F06msportmia]

Thanks!

Actually I already bought the pads (red stuff), ECS Geomet cross drilled/slotted rotors, and a new sensor. I just haven't gotten around to installing everything. $220 for everything not bad a deal and will be doing the install myself.

[Glopez5]

not bad at all, i want to do cross drilled slotted all around and repaint my calipers... in due time lol.