|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
window issue
|
|
03-01-2013, 10:43 AM | #1 |
Private
8
Rep 67
Posts |
window issue
my rear passenger window goes down no problem, but it gets stuck doen and i have to fiddle with the switch a few times for it to come back up. Would this be the regulator or the motor. any help is great!!
|
03-01-2013, 11:15 AM | #2 |
Lieutenant
38
Rep 475
Posts |
Same issue here with my driver's side rear. As long as I don't let it go all the way down, it goes up fine. It is not slow either.
Would love to know more about this. |
Appreciate
0
|
03-01-2013, 11:38 AM | #3 |
Beamer Mantic
82
Rep 1,191
Posts |
You can try to initialize the window. Close the doors, from the drivers switch block, hold the window in the closed position until the window is fully closed. Release the switch, and then hold it up again for another 5 seconds. The window should be initialized at this point.
__________________
2006 325i
2006 M5 2008 X5 4.8i 2014 X5 50i M-Pkg |
Appreciate
0
|
03-01-2013, 07:40 PM | #4 | |
Private
8
Rep 67
Posts |
Quote:
|
|
Appreciate
0
|
03-06-2013, 08:19 PM | #5 |
Registered
0
Rep 4
Posts |
right rear passenger window
I had the same problem where it would occassionally stay down, I replaced the regulator and the problem was not different. I tried the window reset, and now if the window doesn't come up on the 1st try, it goes up in the 2nd or 3rd try. Any ideas?
Last edited by Cols 2006 325I; 03-07-2013 at 06:44 PM.. |
Appreciate
0
|
03-10-2013, 08:30 AM | #6 |
Chief Warrant Officer 4
53
Rep 726
Posts
Drives: 335I, E46 M3, X5M
Join Date: Feb 2007
Location: Back in the US
|
I had the same problem not long ago. I bought a new regulator from the dealer and followed the instructions on You Tube. Before I replaced it, I tested the old regulator after removing it by pluging the wires back in. It worked fine.
I reinstalled it and it has continued to work fine. I lubed the rails and have not have problems since.
__________________
|
Appreciate
0
|
03-14-2013, 08:16 AM | #7 |
Registered
0
Rep 4
Posts |
You tested the original regulator with the motor outside of the door, lubed the regulator and rails, and it worked fine-did you install the new one or the original regulator?
__________________
Garage:
2012 328i 2006 X5 4.4 2006 325i 2009 A4 2.0T |
Appreciate
0
|
Bookmarks |
|
|