|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
NEED advice on amp/set up
|
|
11-07-2009, 07:22 PM | #1 |
Second Lieutenant
10
Rep 297
Posts |
NEED advice on amp/set up
The plan is to add Morels in front doors, replace subs with the SW8's and add audio control dql-8 per tecnic's earlier blogs. So what amps/amp? and how should it be wired? Thanks in advance. Oh, this is in 2009 idrive non logic 7
__________________
2009 AW 328i saddle,zpp, sat, nav, ca, ipod
|
11-08-2009, 08:42 AM | #4 |
Brigadier General
300
Rep 3,969
Posts |
Since you are planing on using a DQL, you do not need an amp that takes differential inputs, so you can choose just about any 4 channel amp there is. If I were you, I would take a digital amp such as JL Audio HD600/4 or Alpine PDX 4150, since they are small, don't produce as much heat as class A/B amps, can be tucked away out of sight, and don't require as much power. Power output should be at least 150W per channel, to do the SWS-8's justice. If you go with the 2 Ohm version of the SWS, you could potentially get away with a 4x100W amp that puts out around 150W - 200W per channel at the lower impedance.
|
Appreciate
0
|
11-08-2009, 09:18 AM | #5 |
Second Lieutenant
10
Rep 297
Posts |
amp
do I leave the factory rear speakers on the factory amp or on the new amp?
__________________
2009 AW 328i saddle,zpp, sat, nav, ca, ipod
|
Appreciate
0
|
11-08-2009, 09:31 AM | #6 | |
Lieutenant General
2281
Rep 12,999
Posts |
Quote:
I would say, get a 6-channel amp/4-ch and a 2-channel and remove the OEM amp if your budget allows. You will have better control of all your system -especially if you are getting a DQL-8 anyways- if you remove the OEM amp from the equation. |
|
Appreciate
0
|
Bookmarks |
|
|