|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Search | Today's Posts | Mark Forums Read |
|
BMW 3-Series (E90 E92) Forum
>
Procede and Procede Fuel Flash
|
|
05-03-2014, 09:37 PM | #1 |
Captain
81
Rep 885
Posts |
Procede and Procede Fuel Flash
DISREGUARD!!
I mixed two of the harnesses (I put gray & black instead of gray & gray duh) Just successfully flashed my ecu with procede fuel flash. I then installed my procede piggyback and the car went nuts. I un-installed the procede and car was fine again. I am going to triple check the install but wanted to reach out and see if the procede needs to be installed first and put in map 0 before flashing ecu or should it not matter? I have installed the piggyback around 10 times and have ran with it for over a year maybe I went too fast and missed something. "Car went nuts" - wipers came and wouldn't shut off on RED service light came on dings beeps and I think I heard faint screaming. And yes "all hail wedge" he has my .bin and is sending me something in the near future which I will run. But I need the o2 modifier to trick o2 sensors for state inspections that the procede provides. Excited to see the result in the morning. Procede Fuel flash with Procede Stage 1 piggyback.
__________________
Last edited by james008; 05-03-2014 at 10:37 PM.. |
Bookmarks |
Thread Tools | Search this Thread |
|
|