|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Winter wheels and tyre pressure monitor
|
|
11-10-2011, 07:20 AM | #1 |
New Member
3
Rep 26
Posts |
Winter wheels and tyre pressure monitor
Hi Guys,
I managed to pick up a set of original 17" BMW winter wheels with Goodyear Ultragrip RFT's on in a cracking deal. They have 6mm tread all round and I will be putting them on in a week or so. Can you advise if I need to reset my tyre pressure monitor? or do I leave it as it is? I am moving from my 18" MV3's with RFT's to these 17" winters. Car is 325D Msport. Thanks |
11-10-2011, 07:31 AM | #2 |
Major General
1399
Rep 8,083
Posts |
If the light comes on then reset it; if it doesn't then don't. Simple.
__________________
Ian
Current: 2021 G21 330i M-Sport Previous: 2018 A6 Avant S-Line MMI+, 2014 F31 320d M-Sport, 2013 F10 520d M-Sport, 2011 F10 530d M-Sport, 2008 320i M-Sport Coupe, 2002 325i, 2001 318i valvetronic, 1998 318i, 1996 525i, 1990 Porsche 944S2 |
Appreciate
0
|
11-10-2011, 07:33 AM | #3 |
New Member
3
Rep 26
Posts |
|
Appreciate
0
|
11-10-2011, 08:10 AM | #4 |
Major General
1399
Rep 8,083
Posts |
As long as your overall diameter is more-or-less the same as it was then nothing will need doing but it's a simple reset if it does
__________________
Ian
Current: 2021 G21 330i M-Sport Previous: 2018 A6 Avant S-Line MMI+, 2014 F31 320d M-Sport, 2013 F10 520d M-Sport, 2011 F10 530d M-Sport, 2008 320i M-Sport Coupe, 2002 325i, 2001 318i valvetronic, 1998 318i, 1996 525i, 1990 Porsche 944S2 |
Appreciate
0
|
11-10-2011, 08:18 AM | #5 |
Brigadier General
224
Rep 3,016
Posts |
Once you have fitted the wheels and, most importantly, established correct tyre pressures you should re-initialise the system as per the manual:-
In iDrive go to page: Vehicle Info/Status/Confirm Tyre Pressure. Start the engine - do not drive off Press controller with 'Confirm Tyre Pressure' highlighted, then drive off. |
Appreciate
0
|
Bookmarks |
|
|