[JazStar740]

Thanks!!! I think I found the conversion harnesses and adapters needed on Bimmer Retrofit

[moreno1]

Anyone know where I can found a DIY on how to remove the back seat and back panel in the trunk on my e93. Just like shown on the first post of this tread. Trying to re-install my combox correctly and I can't get the panel to come of for the life of me.
Any links or guidance would be appreciated!
Thanks a lot.

[jasonn]

Originally Posted by moreno1

Anyone know where I can found a DIY on how to remove the back seat and back panel in the trunk on my e93. Just like shown on the first post of this tread. Trying to re-install my combox correctly and I can't get the panel to come of for the life of me.
Any links or guidance would be appreciated!
Thanks a lot.

http://www.e90post.com/forums/showpo...96&postcount=9

[JazStar740]

Originally Posted by jasonn

http://www.e90post.com/forums/showpo...96&postcount=9

E93 removal is a lot different from this.... Been through the process but no pics

[moreno1]

Originally Posted by jasonn

http://www.e90post.com/forums/showpo...96&postcount=9" rel="ugc" target="_blank">http://<a href="http://www.e90post.c...ostcount=9</a>

Thanks Jasonn but this is for e90/92. The e93 is totally different. After many hours trying i figured it out. Sorry no pics but here are the steps...
1- lower the back seats
2- remove the foldable piece/door for the ski bag
3- you will see on the floor of the ski trap two (2) little pieces
4- use a flat head screw driver to pop those (2) pieces out
5- that will give you access to two (2) 10mm bolts.
6- use a 10mm socket wrench to remove both bolts
7- they are a little hard to remove cause the spacing to enter the socket is very tight.
8- once remove pull on the whole plastic piece
9- go in the trunk and you will see four 10mm bolts as well which are holding the back of the plastic piece you just removes inside the car
10- once you have remove all four bolts you can now pull on that piece as well and the whole ski bag will come out.
11- then if you go back inside the car there will be a black foam on the bottom floor of the ski pass, just remove it. It may require a little force so don't nothing should break :-)!
12- once the foam is out you will then have access to the set of wires going to the TCU/MULF & SAT

Do what you have to do to install the combox then just reverse the steps and all should be good.

Enjoy,