|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
N52 - crankshaft sensor replacing
|
|
04-03-2012, 11:56 AM | #1 |
Registered
4
Rep 4
Posts |
N52 - crankshaft sensor replacing
Hello. Please forgive me if this is not proper place to add this request.
I need to replace in my e90 crankshaft sensor. I didn't find any DIY. The only thing I found is this picture (only shows where sensor is): So please give me any advices or maybe someone has DIY ? I will be grateful. And sorry for my english. |
04-17-2013, 01:36 PM | #3 |
joseph
5
Rep 66
Posts |
it is trickey to manipulate without taking off the intake which is a job in itself. label all wires on removal! careful with the plastic vacuum lines (they take some dexterity) to pinch and pull off at odd angles. when pulling off the intake double and triple check to make sure everything is disconnected off of it and you are not yanking on a wire or hose thats still plugged in causing damage. refer to the TIS or bently manual for further help.
__________________
2006 330i E90 N52 -
Production 10/2005 |
Appreciate
0
|
04-21-2013, 04:05 PM | #4 |
joseph
5
Rep 66
Posts |
i just replaced the crank sensor, and it was not a fun job. I ended up with more problems then i started (because of other factors). Any problems?
__________________
2006 330i E90 N52 -
Production 10/2005 |
Appreciate
0
|
06-16-2015, 12:11 AM | #5 | |
Team iTouge
121
Rep 2,101
Posts |
I know that this is two years later but any updates?
__________________
Quote:
|
|
Appreciate
0
|
Bookmarks |
|
|