|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Search | Today's Posts | Mark Forums Read |
|
BMW 3-Series (E90 E92) Forum
>
DIY Brex White Ring
|
|
03-27-2006, 09:15 PM | #1 |
Major
124
Rep 1,411
Posts |
DIY Brex White Ring
I get this from somewhere in this forum.
It was Japanese. Before install!!! Disconnect your negative teminal to your battery. 1. Lift your car up. 2. Take your wheels out. 3. Unscrew some screws and nuts. (see pics) 4. Unscrew 2 screws on your ring bulbs. 5. Replace them. 6. Put everything back. 7. Done!! So, enjoy!! |
03-27-2006, 09:22 PM | #2 |
Captain
63
Rep 889
Posts |
Is it necessary to take off the wheel, im asking bc one thread for changing the fod lights said to unscrew 7 screws and i did it by taking off only 3
|
Appreciate
0
|
03-27-2006, 09:24 PM | #3 | |
Major
124
Rep 1,411
Posts |
Quote:
|
|
Appreciate
0
|
03-27-2006, 09:29 PM | #4 | |
Lieutenant General
1429
Rep 16,628
Posts |
Quote:
|
|
Appreciate
0
|
06-13-2006, 10:54 PM | #6 |
boku no namae ha...
336
Rep 11,025
Posts
Drives: 2006 BS 330i
Join Date: Feb 2006
Location: S. Bay Area, CA + Newark, NJ + ChiCity + True Blue
|
so wait u can do this w/o taking off the wheel + jacking? jw... cause i'm considering on rings if i can do it without the jack... thnx!
|
Appreciate
0
|
06-20-2006, 11:04 PM | #7 |
Captain
79
Rep 876
Posts |
the brex can not be done without removing the fender well plastic cover I suppose it might be possible to do without taking off the wheel but you will not be able to get any clearance to where you need to be and the brex are pretty deep down in there.. In this case it really works out a lot faster to just take the wheels off...
|
Appreciate
0
|
Bookmarks |
Thread Tools | Search this Thread |
|
|