|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Need help from people that have installed KW v1's
|
|
01-25-2015, 01:41 AM | #1 |
Private
3
Rep 97
Posts |
Need help from people that have installed KW v1's
I got everything bolted up and back together. I was reviewing the directions and noticed they said to remove the washer that's on the front struts if you have an aluminum perch and leave it on if you have a steel perch. This is the one that comes on the front coilovers out of the box. It's on shaft the top nut goes onto. Is the perch steel or aluminum. Did anyone else leave the washer on and did it cause any issues?
__________________
9.29 ET -97' Awd Eagle Talon (2.2 liter long rod/ 6766 vband/ ID2000/ twin bosch 044's/ ecmlink-speed density/ Ksport coilovers/ TRE stage 3 trans/Ptt twin disk/ JM fab fmic)
08' E92 N54 Awd 335xi (KW V1 coilovers/ 18" BBS/ Alpina flash/ Vrsf CP HKS bov/ Vrsf 7' fmic/ Fuel it stage 3/ Cobb V3) |
Bookmarks |
|
|