[dfv2]

BIMMERPOST / Classifieds

Asking Price:

Sold

Or Best Offer

Shipping Costs Included

Location:

✓ Will Ship

Item Interest

ST Kit and Camber Plates SOLD

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

Up for sale is a set of ST coilovers and a 60mm linear spring conversion. I had this on my 135i but the dampers are identical (same part# and all) to to the 335i kit. 8kmi on the coilovers. Since I've used a pair of GC street camber plates on them with both the ST coils and with upgraded hypercoil linear race springs, I have perches for both! This is a perfect setup to fit some wide front 245 rubber on Apex wheels, which worked out perfectly. I'm only selling to move to a custom coilover setup.


ST Coilover Kit (90239)
2001015L/R (front) & 2001115 (rear).
Although shown with GC plates, the plates are not included.
$650 Shipped CONUS:




Linear Spring Conversion for your existing ST/KW Coilovers
GC Camber Plates (E8X/E9X non-M Street) KW/ST w/ OEM & 60mm Perches.
Hypercoil Springs (186M0450) - 6" 450lb/in linear
Swift thrust sheets, 60mm
$400 Shipped CONUS:



OR PACKAGE EVERYTHING:


Full ST Coilover Kit W/Linear Spring Conversion
ST Coilover Kit (90239)
GC Camber Plates (E8X/E9X non-M Street) KW/ST w/ OEM & 60mm Perches.
Hypercoil Springs (186M0450) - 6" 450lb/in linear
Swift thrust sheets, 60mm
$950 Shipped CONUS:



Thanks for looking! Here's a shot of the whole setup on my 1'er with 245/275 F/R (12mm spacer up front). Again, damper PN's are identical to the 335i kit.

[asian010]

question bout the conversion kit. so this kit would work on a kw v2 for 335i plug n play no machining? do you only have the front conversion or do u have the rear springs as well? whats the height adjustability of a 6in spring? 450lb/in front or rear as well if u have the rear.

[dfv2]

AFAIK shock bodies are identical to the 335i kit and so it's 1:1 PNP. The 60mm hypercoils go over KWv1/v2 62mm perches no problem.

Just a front conversion here, used original springs for the rear. Height; lowest is lower than you could ever want. Highest with the 450lb/in spring is less than a finger gap up front before you run out of adjustment threads.

[tigermack]

Would you part the plates?

[dfv2]

Originally Posted by tigermack

Would you part the plates?

I'd like to move the ST kit with/without them. At that point I'd part the plates if they didn't stay with the kit.