[Conti.]

Figured i'd post some pics of tonight's work. Finally had some time to mount summer wheels and install my motorsport hardware stud kit and lugs. just one of many things on this month's to do list..Big thanks to kalib0y for hooking me up with all the parts and fast shipping

Don't mind the dirty car & wheels, one of the things on my list is a full spring polish and clean and a photo shoot with Ridgefield335 and his new setup




hubs were pretty bad from this winter as you can see. nothing a little compressor wheel couldn't take car of





hubs all cleaned up and studs installed. applied a little loctite and torqued the studs down to 25ft-lbs



and one with h&r 10mm spacers installed



and here's a few with the wheels mounted, and lugs on!





sorry for the big crappy pics, was using my phone with a dirty lens.

[Route 16]

looks good
in the future, would the studs have to be removed before putting in new rotors?

[EJ_3]

Originally Posted by Route 16

looks good
in the future, would the studs have to be removed before putting in new rotors?

Nope, he can replace them while the kit is installed. Hopefully he did after he took the pictures. Looks good op, but the lip on those rotors

[Alen E90]

Lookin' good, keep up the good work!

[bfritzsch]

Im confused why you put these on there if you don't have spacers to take up that extra space... Are you planning to add spacers?

[wdeerfield]

wheels look great on there! 10mm spacer fit flush to the rotor surface? my hub extended more than 10mm and i had to get a 12.5mm from TMS.

studs are a little long for my taste. and yea.. you need new rotors.

[Conti.]

Originally Posted by Alen E90

Lookin' good, keep up the good work!

Thanks!

Originally Posted by bfritzsch

Im confused why you put these on there if you don't have spacers to take up that extra space... Are you planning to add spacers?

I do have spacers on, I have 10mm in front and 20mm in the rear.you can see the front spacer on in the pic.

Originally Posted by wdeerfield

wheels look great on there! 10mm spacer fit flush to the rotor surface? my hub extended more than 10mm and i had to get a 12.5mm from TMS.

studs are a little long for my taste. and yea.. you need new rotors.

Yea, the 10mm sits perfectly flush with no issues. my hubs don't extend that far so I still have maybe 2-3mm of space. The lugs stick out a little far with these wheels, but I like seeing them. with the oem wheels the lugs sit in pretty far.


And I know I need to do a full brake job haha. Im already swapping the fluid next week for motul 600 But i think I'm going to wait until this summer and after some laps at LRP next month The pads are thick and still have a good amount of life. I'm waiting until I do everything so i can upgrades pads, rotors and ss lines.

[#Tee]

those are pretty big and long

[mmmnot]

Originally Posted by #Tee

those are pretty big and long

Well, they are black...

[VMRWheels]

Nice, looks like a solid product