BMW 3-Series (E90 E92) Forum > E90 / E92 / E93 3-series Powertrain and Drivetrain Discussions > N54 Turbo Engine / Drivetrain / Exhaust Modifications - 335i > Own the Stett Chargepipe? Got a Meth Kit?

Thread Tools Search this Thread
      08-09-2009, 05:56 PM   #1
aka Trevorsd
SD135i's Avatar

Drives: 2009 135i AT
Join Date: Jun 2009
Location: Las Vegas, NV

iTrader: (0)

Garage List
2009 135i  [0.00]
Own the Stett Chargepipe? Got a Meth Kit?

Last week I installed the Stett pipe and the Coolingmist stage2 meth kit.

I'm looking for others that have a similar setup as I have. I'm curious if others have had similar experiences.

My Setup:
91 Octane
Stett Chargepipe/Tial BoV using the 2nd meth bung
CMGS Stage 2 Meth Kit will progressive controller
80/20 Denatured Alky/Distilled water mix
Typical ambient 95-115
Typical non-cooled IATs are ambient+15degrees
Cooled IAT's down to 60 - this is the CEL threshold
Typical ambient humidity 5-15%

The system is over cooling my IATs. If I set the spray to start at say 6.5psi and max at 15psi, the system will reduce my IATs by up to 50 degrees in just 1 pull. Such an extreme change in IATs causes the ECU to throw the following code/CEL:

2F09 Inlet air temperature sensor, plausibility
Error will cause a warning light
Error is currently present
Test conditions have not been completed
Signal or value below threshold

Event 1Odometer 12448kms 7734miles
Intake air temperature 18.75 C
inlet air temperature at start 60.75 C
ambient temperature 31.50 C
Engine temperature 99.00 C

I can and have corrected the issue by setting the max duty on the controller/pump to 50% thus cutting in half the amount of spray.

I ran a couple of logs to see how my timing is doing with the loss of octane from the reduction in alky and everything appears to be pretty good. I've attached a couple of the graphs. I tried to stick to 4th gear for the logs but kicked down a couple of times.

Thanks for your input. Hopefully I find a couple others with similar setups.
Attached Images
JB3 2.0 Beta 18 ohm| BMS DCI | BT Tool | BMS Tuning Guage | BMS o2 Fix | BMS Stage 3 Chip Burner
AR Design CL DPs |Helix FMIC | KDW2s | H&R Sport Springs | 3M 35% Tint
Coolingmist CMGS Progressive/Fail Safe Meth Kit w/Flow Sensor
Appreciate 0


Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -4. The time now is 12:51 PM.

Powered by vBulletin® Version 3.7.0
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
1Addicts.com, BIMMERPOST.com, E90Post.com, F30Post.com, M3Post.com, ZPost.com, 5Post.com, 6Post.com, 7Post.com, XBimmers.com logo and trademark are properties of BIMMERPOST