Login
![]() |
![]() |
![]() |
![]() |
![]() ![]() |
![]() |
BMW Garage | BMW Meets | Register | Search | Today's Posts | Mark Forums Read |
![]() |
![]() ![]() |
BMW 3-Series (E90 E92) Forum
>
Passport SRX Install
![]() |
![]() |
10-13-2010, 10:06 AM | #1 |
Banned
![]() 188
Rep 5,022
Posts
Drives: VALNCYA
Join Date: Jan 2009
Location: Jersey
|
![]()
First Remove the bumper
2 bolts going into the fender 3 on each wheel well 7 underneath the bumper 4 upper grills Bumper will practically fall off Next Start cutting the grill area. LEFT RIGHT I used 3M Automotive tape and straps to secure Right side Then I ran the Wiring and taped it up into the DME Box into the glove box and tagged all cables. Glove box connected Installed the display into the ash tray. ![]() Installed the speaker under the drivers seat (yes it clears the movement of the seat) ![]() Signal Stalk mute button ![]() Concealed Display ![]() Rear Jammer was installed into the rear brake lamp (for an invisible install) COMPLETE (Testing results to come) |
10-21-2010, 05:51 PM | #2 |
Lieutenant Colonel
![]() 39
Rep 1,708
Posts |
so you ran your wires to the DME box and then through the firewall into the glove box. Can you elaborate on how did you get into the DME and through the firewall. I assume you're using the cooling fan hole in the DME box to get inside the car, but how about into the DME box from the engine?
|
Appreciate
0
|
01-18-2011, 05:23 PM | #3 |
Banned
![]() 188
Rep 5,022
Posts
Drives: VALNCYA
Join Date: Jan 2009
Location: Jersey
|
Yes just came into the side of the oem wiring put the oem wiring on top of the sealed DME box
|
Appreciate
0
|
![]() |
Bookmarks |
Thread Tools | Search this Thread |
|
|