E90Post
 


N54Tuning.com
 
BMW 3-Series (E90 E92) Forum > E90 / E92 / E93 3-series Technical Forums > DIY Guides > DIY - SQUEAKS AND RATTLES E90 330Xi *Rear folding seats. Another Fix



Comment
 
Tutorial Tools Search this Tutorial
DIY - SQUEAKS AND RATTLES E90 330Xi *Rear folding seats. Another Fix
Published by Cygnusx1
11-23-2011
DIY - SQUEAKS AND RATTLES E90 330Xi *Rear folding seats. Another Fix

I thought I had the common rear deck squeak/rattle, but after some inspection by banging the rear seat backs around, I found the culprits.

Part 1:

1) If you have the fold down rear seats you know that they can make noises. Fold down both sides.

2) Remove the seatback corners that are just below the C pillars. Grab them near the top and pull forwards with about 20 pounds of force. They will release up top, and then pull them straight up to get them out completely.

3) There is a white plastic retainer that is snapped into the steel body. Remove the retainers from the body by pressing down the release tabs inside the retainers. (one on each side of the car).


4) Coat them with a light coat of synthetic grease in and out. I would not use a petroleum product because it may harm the plastic.

5) Snap the retainers back into the seat back corners, not the body.

6) Apply some grease to the plastic mating pins on the bottom of the seatback corners.

7) Reinstall the seatback corners. Lower pins in first, look behind them and align the plastic retainers with the holes in the body and give them a firm push back into position. They snap in easily. Note: Make sure the seat belts are not caught back there before you snap them in place.


Part Two:

1)With the rear seats folded down, squirt some WD-40 at the seatback hinges on either sides of the car, and at the center hinge as well.

2)Grab the seat backs and force them left to right and swing them up and down a few times, to let the WD-40 work into the hinges.


3)Spray WD-40 at the Steel Hooks on the back of the seatbacks. Most of the squeaking was coming from the actual Hook built into the seatback! (you can actually push hard on the hook and hear it squeaking, which is how I located it.) Make sure to get some lube down into where the hook goes into the fabric.


4) Put the seats back up, wash your hands, and go for a test drive!


Good luck.
-Dave
__________________

Straight-Six Addict - Dave
Tutorial Tools
  #1  
By 325xi-06 on 11-23-2011, 08:26 PM
thanks man i'm gonna try this out tomorrow mine squeaks as hell...
Reply With Quote
  #2  
By dalpert on 08-12-2012, 03:23 PM
Member reviews
Difficulty [ 1 = Difficult ]
20%20%20%
1
Cost [ 1 = Expensive ]
20%20%20%
1
DIY Clarity [ 1 = Not clear ]
20%20%20%
1
Average 20%
sqeaaks & rattles

Great info, 20 minute job at most. Problem fixed! Thanks for the post
Reply With Quote
Comment

Bookmarks

Tutorial Tools Search this Tutorial
Search this Tutorial:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -5. The time now is 01:59 PM.




e90post
Powered by vBulletin® Version 3.7.0
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
1Addicts.com, BIMMERPOST.com, E90Post.com, F30Post.com, M3Post.com, ZPost.com, 5Post.com, 6Post.com, 7Post.com, XBimmers.com logo and trademark are properties of BIMMERPOST