E90Post
 


TNT Racewerks
 
BMW 3-Series (E90 E92) Forum > E90 / E92 / E93 3-series Technical Forums > Mechanical Maintenance: Break-in / Oil & Fluids / Servicing / Warranty > Engine Idles and Acceleration Stutter



Reply
 
Thread Tools Search this Thread
      12-28-2012, 02:04 PM   #23
daveymcmillan
New Member
4
Rep
21
Posts

Drives: 2006 325xi
Join Date: May 2011
Location: Dayton, OH

iTrader: (0)

I'd recommend changing the spark plugs before changing the coil first... that fixed my issue altogether.
Appreciate 0
      12-28-2012, 02:19 PM   #24
GoRomeo
Colonel
GoRomeo's Avatar
72
Rep
2,717
Posts

Drives: 330i
Join Date: Feb 2006
Location: San Diego CA

iTrader: (0)

Garage List
2006 330i  [2.83]
Quote:
Originally Posted by new0rder View Post
this just to follow up my last post, my rough idling issue. so I did replace my ignition coil, just 1, everything works fine... until now I got another misfire, now its cylinder 6, I guess its on going, I am ordering another one.
Thanks for sharing and follow up. Great info. Keep us posted.
Appreciate 0
      07-22-2016, 02:16 PM   #25
bimmbo
Registered
0
Rep
2
Posts

Drives: 2007 BMW 328iT
Join Date: Jul 2016
Location: Oakland, CA

iTrader: (0)

Leaking eccentric shaft sensor seal

Been searching the forums for months on this issue and was never able to find anything solid . To be more exact, I had rough idle and bad hesitation on the highway accelerating from low RPM. Issue was worse when the AC was pumping hard to the point where if I pumped the throttle or tried to accelerate from low RPM (about 2500) for any extended period of time there would be hard engine stuttering. At some points I would get the SES light on and once that happened the car was barely driveable; basically couldn't accelerate. Restarting the car would clear the SES light and no codes could be found, but when the SES light was on I was able to pull a pending code: P0303 Cylinder 3 misfire. Great so now I had a place to start. Swapped the ignition coil with Cyl 2 and spark plug with Cyl 1 to see if I could get the SES fault to migrate to one of the other cylinders. While I had the engine cover off I decided to look at the eccentric shaft sensor connector as I had read about he seal leaking oil into it. Sure enough it had a bunch of oil in it, so I cleaned the connector and harness plug out with isopropyl and cotton swabs, then blew it dry with compressed air. Smeared dielectric grease on the harness plug and reconnected it. Took the car out for a spin and no rough idle and no hesitation while accelerating from low RPMS. Even pumped the throttle repeatedly with the AC cranking for the whole 15 minute drive and no hesitation! Took it for a second 15 minute drive an hour later and then a 30 minute the next day and issue still has not repeated. I'm sure the issue will resurface once the oil has had time to leak into the connector again, but at least I know what needs to be replaced: a $7 eccentric shaft sensor seal.
Appreciate 0
      07-22-2016, 10:25 PM   #26
kkasson
First Lieutenant
56
Rep
371
Posts

Drives: 2007 BMW 328i
Join Date: Jun 2015
Location: Ojai, CA

iTrader: (0)

Quote:
Originally Posted by bimmbo View Post
I'm sure the issue will resurface once the oil has had time to leak into the connector again, but at least I know what needs to be replaced: a $7 eccentric shaft sensor seal.
Typically the sensor fails internally which allows oil to leak into the pins. The seal keeps oil from leaking outside of the valve cover, but the oil will still leak into the connector.

I see that you're in CA, though. Does your 328i have an N51? If so the eccentric shaft sensor is covered by the SULEV warranty for 15 years/150k miles. I had mine (and the valve cover gasket) replaced for no charge at the dealership.
Appreciate 0
      08-09-2016, 03:03 PM   #27
DRAY8110
New Member
0
Rep
7
Posts

Drives: 2011 BMW 335i E92
Join Date: Aug 2016
Location: Destin, FL

iTrader: (0)

2011 N55 stutter under 75% acceleration

Found in another thread, delete

Last edited by DRAY8110; 08-10-2016 at 01:56 PM. Reason: Found in another thread
Appreciate 0
Reply

Bookmarks

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -4. The time now is 10:15 PM.




e90post
e90post
Powered by vBulletin® Version 3.7.0
Copyright ©2000 - 2016, Jelsoft Enterprises Ltd.
1Addicts.com, BIMMERPOST.com, E90Post.com, F30Post.com, M3Post.com, ZPost.com, 5Post.com, 6Post.com, 7Post.com, XBimmers.com logo and trademark are properties of BIMMERPOST