[seemebreakthis]

Is there any way to have the digital speedometer appear without pressing the BC button when u turn on the ignition?

Thank you!!

[alexwhittemore]

At least in my car the computer will always display the previously selected readout - I usually leave mine set to trip MPG, and it comes back up every time I restart the engine.

[Johndong888]

if you have it in the "V" mode, it should always start up in "V"

[seemebreakthis]

Hmm... this is actually not the case over here. Take a look at my video here:

Notice how it shows the "V = x km/h" screen and then after I stop/start the car the display goes back to the digital odometer default.

[alexwhittemore]

Does it not then change back to the info function when you start the engine?

[Neutrino45]

The video is in bad quality.

[seemebreakthis]

Originally Posted by alexwhittemore

Does it not then change back to the info function when you start the engine?

It changes back to the odometer function when I restart the engine.

So every time I have to press the BC button to get the "V = 0 km/h" to be displayed once again. Not anything major but this is just a nagging problem that I'd like to fix if possible...

[onebadmofo]

This is pretty unusual. Just curious, post the contents of your KOMBI module, use pastebin.com

[seemebreakthis]

Here you go! Thank you.

http://pastebin.com/13HDxqaz

[roadkillrob]

Weird, mine stays where it is when the car is shut off.