E90Post
 


 
BMW 3-Series (E90 E92) Forum > BMW E90/E92/E93 3-series General Forums > General E90 Sedan / E91 Wagon / E92 Coupe / E93 Cabrio > Error code help



Reply
 
Thread Tools Search this Thread
      01-06-2013, 08:59 PM   #1
pwdrtoastman
Second Lieutenant
No_Country
6
Rep
222
Posts

 
Drives: 2007 BMW 335i
Join Date: Dec 2010
Location: Colorado

iTrader: (-1)

Error code help

All,
I have these codes in my 07 335i after installing my DPs. Can somebody help me figure out if this is a simple 02 code or if its something else.
Thanks.
urrently present
Test conditions have been completed
Timeout

Freeze Frame Information
Event 1Odometer 93168kms 57891miles
speed 704.00 rpm
suction pipe pressure 38.00 kPa
relative load 0.00 %
matching throttle valve model (factor) 1.13 -



29E1
29E1 Fuel mixture control 2
Error will cause a warning light
Error is not currently present
Test conditions have been completed
Timeout

Freeze Frame Information
Event 1Odometer 93168kms 57891miles
speed 640.00 rpm
suction pipe pressure 37.00 kPa
relative load 0.00 %
matching throttle valve model (factor) 1.12 -



2ABC
2ABC Charging pressure sensor, electrical
Error will cause a warning light
Error is not currently present
Test conditions have been completed
Short circuit or signal interruption

Freeze Frame Information
Event 1Odometer 93184kms 57901miles
Engine speed 2,560.00 rpm
pressure in front of throttle valve 251.00 kPa
throttle valve actual value 1.87 TPS
status motor control 2.00 0-n



3100
3100 boost-pressure control, deactivation
Error will not cause a warning light
Error is not currently present
Test conditions have been completed



29F4
29F4 Catalytic converter conversion
Error will cause a warning light
Error is not currently present
Test conditions have been completed
Short circuit or signal interruption

Freeze Frame Information
Event 1Odometer 93192kms 57906miles
Engine speed 2,432.00 rpm
air mass calculated 119.37 mg/stk
Engine temperature 95.25 C
Intake air temperature 17.25 C

Event 2Odometer 93224kms 57926miles
Engine speed 2,400.00 rpm
air mass calculated 238.74 mg/stk
Engine temperature 95.25 C
Intake air temperature 3.00 C



29F5
29F5 Catalytic converter conversion 2
Error will cause a warning light
Error is not currently present
Test conditions have been completed

Freeze Frame Information
Event 1Odometer 93192kms 57906miles
Engine speed 2,432.00 rpm
air mass calculated 157.35 mg/stk
Engine temperature 94.50 C
Intake air temperature 17.25 C

Event 2Odometer 93224kms 57926miles
Engine speed 2,368.00 rpm
air mass calculated 227.89 mg/stk
Engine temperature 95.25 C
Intake air temperature 3.00 C
__________________
2007 BMW AW 335i
Mr.5 Intake///HKS SSQV///Race Land DP///JB4
10in. JBL W3///JBL GTO AMP///LC2i
Appreciate 0
      01-06-2013, 09:09 PM   #2
HaroldLee
Banned
HaroldLee's Avatar
0
Rep
38
Posts

 
Drives: 08 E90
Join Date: Jan 2013
Location: Cali

iTrader: (0)

Think you will have to take it to a shop and have them deleted the code. But idk for sure. Its hard to tell what the code is. Take a pic of your dash with the error light.
Appreciate 0
      01-07-2013, 01:03 PM   #3
pwdrtoastman
Second Lieutenant
No_Country
6
Rep
222
Posts

 
Drives: 2007 BMW 335i
Join Date: Dec 2010
Location: Colorado

iTrader: (-1)

I zero'd it out and have driven 18 miles, CEL has not come back on yet. Hope it stays that way and nothing new pops up
__________________
2007 BMW AW 335i
Mr.5 Intake///HKS SSQV///Race Land DP///JB4
10in. JBL W3///JBL GTO AMP///LC2i
Appreciate 0
      01-07-2013, 01:17 PM   #4
Bimmer Barney
First Lieutenant
Bimmer Barney's Avatar
5
Rep
387
Posts

 
Drives: 2007 335i Sedan
Join Date: Jan 2011
Location: Santa Barbara, CA

iTrader: (4)

29F4 and 29F5 are associated with c@less downpipes and can be suppressed with a tune or DP Fix. The 3100 is nothing to worry about, just indicates you went into limp mode. Not sure about the others, just google it.
__________________
2007 SGM E90 335i
JB4 G4, Mr.5 Intake, VRSF 7" FMIC, ER Sport Oil Cooler, RB PCV Valve, Cyba Scoops and Quad Tips, 17x9 ET30 and 17x9.5 ET35 Concave Apex Arc 8, M3 UCA/LCA
Appreciate 0
Reply

Bookmarks

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -5. The time now is 02:31 PM.




e90post
Powered by vBulletin® Version 3.7.0
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
1Addicts.com, BIMMERPOST.com, E90Post.com, F30Post.com, M3Post.com, ZPost.com, 5Post.com, 6Post.com, 7Post.com, XBimmers.com logo and trademark are properties of BIMMERPOST