FORUMS
- 5
 |
 |
 |
 |
 
|
 |
BMW Garage | BMW Meets | Register | Search | Today's Posts | Mark Forums Read |
 |
|
BMW 3-Series (E90 E92) Forum
>
Need these torque specs ASAP
|
 |
| 02-18-2013, 10:02 PM | #1 |
|
Colonel
 
|
Need these torque specs ASAP
My buddy has my damn manual and is out of town
 and I think I know the torque pecs but want to be 100% sure nice I am making a DIY:Drive shaft to differential "insert nut" (I believe it is 55 lbs) Drive shaft flex disk "guibo" (was told 65ft lbs but want to be sure) I had them written down but can't find them, no loaning out my Bentley manual again lol!!
__________________
JB4 G5 ISO+BMS flash,Walbro 455 LPFP, DO meth kit 4-AN SS lines, BMS OCC, RB turbos W/3.5 N20 sensor, RB valve, BMS DCI, 3" AR kittyless Dps, Strett 2 oil OC W/ SS lines, ER FMIC, ER CP W/HKS BOV, M3 control arms, M3 Strut Brace, M3 front sway-bar, Meyle HD tie-rods, HPA rear toe arms, Wavetrac LSD, DEFIV differential kit, BC Coil-overs, Power-Flex subframe bushings, stoptech slotted rotors, Rogue Tranny Mounts, Concept 1 CS-5.0 rims,
|
|
|
 |
| Bookmarks |
| Thread Tools | Search this Thread |
|
|
