|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Search | Today's Posts | Mark Forums Read |
|
BMW 3-Series (E90 E92) Forum
>
Lower Control Arm question
|
|
11-12-2013, 09:51 AM | #3 |
Private
6
Rep 58
Posts |
Ok but if I'm using a torque to apply the specific torque from the Bentley manual.
The torque will be on top of the knuckle so how can I hold it to prevent to spins |
Appreciate
0
|
11-12-2013, 11:56 AM | #4 |
DIYER
607
Rep 5,521
Posts |
use impact then torque...it will not move. I have done 15 sets this way. If no impact, tighten nut with box end wrench and hold with torx bit until tight then torque to spec.
__________________
JB4 G5, Stage 3 LPFP, Stage 2 MOTIV PI, VM 6466 ST, Custom OCC W/ SS lines, ER FMIC, ER CP W/HKS BOV, M3 control arms, M3 guide rods, M3 upper links, M3 front & rear sway-bars, HPA rear toe arms, Wavetrac LSD, HPF Gen 2, DEFIV kit, KW clubsport, Delrin solid SF bushings, stoptech rotors, Rogue Tranny Mounts, 1M bumper, M3 CF hood, M3 fenders, M3 OEM sideskirts, Mtech rear bumper, CSL trunk, MORR VS8.2 rims 245/295
|
Appreciate
0
|
Bookmarks |
Thread Tools | Search this Thread |
|
|