Quote:
Originally Posted by RimasRS
Ok I know what you mean can you advice how it is better to measure I was thinking to put sideshafts and diff bolt everything to place where it should be and then just measure using simple role tape. Or you can advice something different?
|
If I had the diff in place, id maybe use picture wire (or something that wont stretch when its pulled tight).
Id get a jubilee clip and clamp the wire to the end of the diff - id mark on the wire with a pen were the edge is.
Id then pull the wire out all the way to the gearbox rubber flange/coupler, as tight as I could. Id then mark on the wire the point were it reaches the outer edge of rubber flange/coupler. Id be looking to use the same outer edge that the wire is attached to on the diff ( ie bottom to bottom)
Thats kind of how I see doing it in my head - hope it helps a little. Ill try and pchop a diagram if it helps??