Quote:
Originally Posted by Nigelo
If I had the diff in place, id maybe use picture wire (or something that wont stretch when its pulled tight).
Id get a jubilee clip and clamp the wire to the end of the diff - id mark on the wire with a pen were the edge is.
Id then pull the wire out all the way to the gearbox rubber flange/coupler, as tight as I could. Id then mark on the wire the point were it reaches the outer edge of rubber flange/coupler. Id be looking to use the same outer edge that the wire is attached to on the diff ( ie bottom to bottom)
Thats kind of how I see doing it in my head - hope it helps a little. Ill try and pchop a diagram if it helps??
|
Thank you so much you are really helpful. Diagram would be nice.
And i was asking of your measurements just to have to compare with somebodys measurements
Thanks again