Quote:
Originally Posted by Burny
Hi all, finally managed to get the 3 disks burnt and verified, all burnt at the slowest speed inserted the first disc put my fsc code in and it started to install the updates, after quite a while, over an hour, it asked for disk 2, installed the disc and it just sat on the screen asking for disk 2 to be inserted.
Left it for ages and nothing, finally had to cancel as it was doing nothing.
Inserted disc 1 again and it started to do the update again (didn't need to input the code this time) so cancelled it inserted disk 2 just to check if the drive could read the disc and again after a few seconds it tries to start the update again and it says disk 1 of 3. So is that correct will it start the update even if disk 2 is installed first?
Has anyone any ideas why it doesn't seem to want to continue updating from disk 2 even though its reading the disk if it's inserted first.
Thanks
|
Suggest you reverify the files for disk 2 to be sure you got a good copy then maybe try a reburn with decent disks (plus tick verify option for disk burn). Think disk 2 was the biggest so any burn issues most likely to show up here? Load from DVD takes ages, definitely so much faster from usb for anyone who can do so