My ICOM B clone is testing ok, but I still can't get the CIC to start the programming cycle. I have double checked everything I know to check, but still not making any progress. I had the UIF of the CIC before doing anything, so I know what ZB # it used. The MOST Bus loop is closed, & I have even built a most loop for only the CIC & ICOM B.
I have all of the needed software & hardware, it just want get the program status 12. I suspect that the TCU is also part of the problem, as it is showing some error faults in Toolset32.
Help need badly!
Thanks!
|