Quote:
Originally Posted by Connors N54-N55
Wait a minute, so you used a piece of conductor (wire like for houses?) to bend it perfectly to the nipple where the line needs to meet the turbo? Cause if that works, my man your brain is huge
|
yup.
If you enter from the front, then there is not much bending to it.
maybe a slight curve.
pretty much a direct shot.
but make sure you cut your vacuum like before hand so it is not too long of short.
you left hand will guide the coper wire into the actuator nipple, then just drop your vacuum like on it, and then again with the left hand, just push it in.
once in, just take out the cooper wire....your done.