Quote:
Originally Posted by CarAbuser
Do you have a laptop with Tool32 or INPA installed?
Extremely unlikley that MHD hard bricked the DME as they have good safeties in place during the write. But it is possible to soft brick when writing their MHD+ bin files from Github.
If you can use Tool32 and get any sort of successful communication when running the ident job or fs_lesen then you are ok and can recover it. Otherwise it's a new DME that is needed.
Syvecs would be a waste of time though. You'll spend thousands getting it set up and it'll drive like crap.
|
no coms on Tool 32 at all. wont' even run the job, jusdt get initialization error
i'm sending it to ECU pros, figure it will need the case cracked and pogo pins on the board to reload the infineon tricore processor boot sector.