Quote:
Originally Posted by Josh49
Good question. The ends of the wire are phone cord size, however, I don't know how they have the pinouts setup. Personally, I would just buy the one directly from them. That straightwire is all you need. On the one end it has a box for the concealed display, and then a - and + wire. The - wire you can ground to the torx bolt on the left side. The + side you can ground to the fuse tap I talked about. It will be protected by the fuse in the acc. side of the fuse tap. Also then you will have the little black box there if you ever want to add a concealed display.. Which I think you said you were interested in..
Josh
ONE SEC - I'M LOOKING AT THE V1 WEBSITE TO MAKE SURE I'M NOT MISINFORMING YOU.. I'LL POST AGAIN IN A SEC..
|
So if I just get the straight power cord, this is how it'll go correct? Connect the V1 to ? via the Straight power cord, but if I had the direct wire power adaptor, i would connect the V1 to the direct wire adaptor via the straight power cord, the direct power cord would be hard wired in and then another straight power cord, (that comes with the concealed display) to the concealed display. correct? are you saying that I can make my own direct-wire power adaptor, this is pretty much a middle man that is hardwired in to connect the V1 to the concealed display.