|
There is no need to put any new wires.
What you need is 2 short (5cm) wires & four connectors - two for each seat (part no 61138364842 or 61138364844 - depending on the wire thickness).
Pull out yellow socket from under the seat (before disconnect battery), dismantle it (you need 2 screwdrivers), slide out black part with cables out of yellow cover.
If you have heated seats they are powered by pin 4 (+) and 8 (-).
Just take out this two pins and solder to them short cable (you have to peel off from the connector a little bit of the material - if not solder would not "stick" to it.
On the other end of this cable you solder or "squeeze" connector
You put this connectors to the socket on the pins 9 and 13.
To sum up: 4 connected to 9 (both +) and 8 you connect with 13 (both -).
Put everything together, connect the battery. It's about one hour.
|