View Single Post
      01-22-2022, 07:18 PM   #8
CamJam
New Member
4
Rep
11
Posts

Drives: 2007 335i
Join Date: Jan 2022
Location: Arizona, USA

iTrader: (0)

Quote:
Originally Posted by iqraceworks View Post
FYI....you can also get a set of large metric open end wrenches (including 50mm) from Harbor Freight for around $60.
I did consider that, but it looked like the HF wrench was a tad too thick and would require grinding down to fit. What I did get at HF though was a Bearing Separator and Puller Set (#62593) for $50. It made short work of removing the CSB from the driveshaft.

BTW, the new insert nut is a whole lot easier to put on than it was to get the old one off. I guess it takes 15 minutes or so for the thread sealant to kick in.
Appreciate 0