Quote:
Originally Posted by Cbozz
the oil cooler side all aligns perfectly with your oil cooler screws on the oil cooler side, then on the bumper sire I cut off all tabs because oil cooler side is holding the duct sturdy and then the bumper side overlaps the bumper hole so it's holding up great, the driver side on the other hand I left the top tabs on the bumper so I can screw it to the duct I cut a small slot in the duct and overlapped it with the bumper tab and then screwed it together then on the side of the brake vent hold I just used the duct's screw tab and just drilled a hole in the wheel well and put the screw through it so it's holding it in place... once you see it you'll figure it out I'm sure!! lmao this all sounds like gibberish
|
Ok. If can picture it now. That's the most detail I've ever heard about how it is done. This should be in the diy section.
Thanks a lot!