Need Audio Help, MS8 + Alpine PDX 4.100
Dear Friends,
Have already posted in Audio thread but in case some of you clever people from the UK dont go to that thread - need some advice,
My current Audio setup includes,
Front Stage = Logic 7 Mids and Tweets
Centre = Logic 7 mid and tweet
Rear Stage = Logic 7 mids
Subs= Earthquake SWS8's
Processor= JBL MS8
Amp = Alpine PDX4.100
So I fitted the Amp and the subs at the weekend with a view on the amp running the front stage and the subs.
My primary question is that the amp has its own crossovers and filters. I have set the filters on the channels to 'off' and the crossover on the sub channels to 40Hz and the front stage to 150hz.
Am I doing this right ? What should I set the crossovers to ? Should I turn the filters off, asumption that the MS8 shoudl do this work ?
On the MS 8 I have set the crossover point at 40HZ for low pass and the high pass at 200HZ. I have arranged the speaker set up as:
FL + FR as 1 way 200HZ 24DB
Centre as 1 way 200HZ 24DB
Rears as 1 way 200HZ 24 DB
Subs x 2 30HZ 12DB
Any pointers warmly welcomed - especially with respect at what I should set the amp crossovers at and whether I should be using the filters on the amp ?
Thanks for reading !!
__________________
Engine Mods: VF HEX Stage 2, ER Charge Pipes, VRSF Catless Downpipes, BMS Intakes and PCW Exhaust Mod
Running Gear Mods: HRE Flow Form F01, Yellow Stuff pads.
Cosmetic: Performance Grill, Lip Spoiler, Splitters, Side Skirt Extensions, Diffuser and BMS Tips
|