Quote:
Originally Posted by Turbid
F80 hubs are same like m3 9x? I though they have a bit different suspension.
I could design and make adapters for you aswell if I knowed difference.
For carbon ceramics brackets not the problem but price for ceramic discs.
|
i think the spindle is the only thing i need but to make life easier, i got the whole set (spindle, knuckle, etc.) i think the only part i need is 31212284002 and 31212284001 but if i get that part alone, that mean i have to remove everything else and just putting that part. I got the whole set on fleebay for right and left. Below is link to fleebay and i bought right and left. The rear for m3, i just need two washers and fit perfectly.
https://www.ebay.com/itm/Front-Right...oAAOSw6D9dOfep
Here link that discuss about e9x m3 using f80 brakes. if you can design the bracket for it, man it save a lot of headache. My issue is that i bought it from fleebay already. If you can design the bracket then there no need to adjust the speed sensor. Base on the thread below, i have revert the speed sensor to 180 degree.
https://www.m3post.com/forums/showth...375975&page=10