View Single Post
      10-26-2015, 06:20 PM   #101
Enlisted Member

Drives: 2007 335i
Join Date: Oct 2015
Location: Las Vegas

iTrader: (1)

Not exactly, i didn't liked the idea of drilling holes, i wanted clean look as much as possible.
I places the board on the same angle but i left the lens to hang as i can adjust it later.
I used a piece of rubber so the lens can hold tension and not move around or vibrate

I also ran the wire in the little hole, for that purpose i had to cut the usb cable and remove the shielding on the one end so its more agile.

Then i used a second USB cable to extend it all the way to the fuse box

And i can easily access it to transfer the needed files

I also had to make a special tool to remove my glove box, cuz i was too lazy to go to the store
Appreciate 0