Quote:
Originally Posted by apexit4
Quote:
Originally Posted by Pep423
The nightmare continues!
The tolerance is too tight with the bearing that was ordered. They (the shop) apparently polished/cleaned the crankshaft but still didn't work.
Now the shop is looking to get an undersized (thinner) bearing. This was yesterday. As of today I don't know if they have found anything.
I can't believe they didn't check the main bearings in the first place even though that's the reason I took the car there in. I told them the dealer thought the issue was either a rod or main bearing.
I'm getting very impatient with not only how this thing has gone down but also with the shop not being very proactive in their communications.
|
Has the shop mentioned how they will go about finding the undersized bearing? If the end caps are machined to match the crank, it might be hard to locate one that will match yours. |
No but I have a call with them this afternoon to discuss all options including calling it quits.
I'm at the point where I need to move on one way or another.