RC, here are the steps
1. open trunk
2. on the ledge of the trunk/bumper, use small flat tool to pry up two small black cover near the rear taillight assembly, one on each side. Unscrew 8mm screws.
3. remove both taillight assemblies....just the outer ones.
4. put an old blanket under the bumper and get on the ground, remove all the 8mm black screws you see under the bumper.
5. inside each rear wheel well are three 8mm screws holding the bumper on. Two you can see. Last one at the top you have to pry back the carpet/liner to unscrew. No need to remove rear tires. Use small ratchet with 3" extensions.
6. now grab left side of rear bumper and gently pop it out. You'll feel two pops when done correctly. now go to the right side and repeat.
7. now stand in the back of the bumper and pull entire cover away from car. Blanket is there to protect bumper just in case it fall to the ground scratching your paint.
Not responsible for any damages....thus DIY. I followed these steps and things went very smoothly. Good luck.
