Other questions: If programming via ISTA/P do I need to change any settings for MOST in remote.ini and EDIABAS.ini?
Or change settings in ICOM? My current settings and status in ICOM:
Mode: ISPI-Next
state free
FW: 03.15.00
System image: 01.26.00
Application image: 01.41.00
STATIC-IP
169.254.33.45
255.255.0.0
I found a post where mentioned: "Since STATIC_IP is only required for EDIABAS functionality but DHCP is a must for ISTA/P" and reverse via iTool Radar. Or it is not needed now with ISTA 4.06 (2017.05)?
Sorry for lots of questions but I have never programmed my car and I just wanna fix my Bluetooth ULF module programming status is 12 problem.
Thanks again!
|