Quote:
Originally Posted by AstroZ
Thanks! Still waiting for it to arrive. Will try it out and let you know about the firmware
|
So it arrived and I fitted it, all working without any need for a software update. Wiring the same as my previous unit too. Woo.
I got the RSE DVB-T2 unit with three antenna ports, so had to add another antenna so that it would start scanning. The new unit is from a F90 but also goes in G11/G12/G30/G38. label of the new unit:
My previous unit was an E70 DVB-T(1) without RSE. label of my previous unit:
Interestingly my supplier sent me the cut connector. It looks like the RSE unit sends two lots of CVBS/FBAS (analogue video) signals out. The first is for the CIC, and the 2nd is for rear entertainment system. The wiring for this unit is as follows:
RSE FBAS 1:
pin2=video+ (blue)
pin8=video- (white)
pin7=shield (black, not strictly needed for short wiring runs)
RSE FBAS 2:
pin3=video+ (yellow)
pin9=video- (white)
pin11=shield (black, not strictly needed for short wiring runs)
the other pins are as usual
12v power = pin 1
gnd=pin 12
(sorry about the photo width, anyone how how to fix that?)